无热再生吸附式压缩空气干燥机
Heatless Purge Desiccant Compress Air Dryer
产品特点
工艺流程Technical fl ow
Product character
具有稳定一致的出气压力露点
A、合理的筒体设计，保证了压缩空气与干燥剂的接触时间微4.8秒，满足成品气的露点要求。
B、30%的干燥剂余量，用于补偿干燥剂的自然老化，确保干燥效果。
C、大型扩散器，确保气流均匀通过干燥剂层，消除沟流现象。
再生气量损耗小于12%
A、卓越的机简设计，保存95%的吸附热量，储存的热量用于增加再生阶段的再生气温度，提高设备的解吸能力，使得再生更彻底。
B、干燥和再生产采用反对流方式，湿空气流过干燥的吸附时效果最佳。
C、可根据干燥机的运行负载需求调节再生产用量。
干燥剂使用寿命长
A、合适的机筒尺寸，使气体通过干燥剂层的流速和时间保持最佳状态，充分发挥干燥剂的性能。
B、合理的系统配置，在气流进入机筒前，经高效除油处理及时清除气流中所含油份与重污染，避免干燥剂层受污染。
设备采用了进口碟阀和先进可靠的微机程序控制器，具有自动计时、自动切换工作的特点。工作稳定可靠，不受电网、电压、电场等影响。
科学合理的切换时间设计保证出口气稳定无波动。
无需基础安装，安装简便。
Consistent outlet pressure dew points
A、Rationalizing designed tower, ensure 4.8 second contact, enough to dry saturated air at the dryer inlet to the desired dew point.
B、30% extra desiccant provide to compensate for natural bed aging ,ensure top perfofmance of desiccant bed.
C、Large flow diffusers ensure even flow distribution through bed, eliminates channeling.
Minimum purge air use, less than 12%, the lowest in the industry.
A、Excellent designing tower, saves 95% of the heat of adsorption, stored heat maintains purge air temperature during regeneration,
maximzing the purge air’s ability to carry off moisture, minimizing the amount of purge air required.
B、Drying and purging in counter flow arrangement, energy not wasted when wet air travels through dry desiccant.
C、Ability to match purge air travels through dry desiccant.
Long desiccant life
A、suitable tower sized make the air velocity through the bed won’t fluidize desiccant, making good use of the desiccant
B、Rationalizing system, remove oil and heavy contaminants before flow into the tower, protects bed from contamination. Using butterfly valve
and reliable program controller which can be auto timing and auto switching, works stable and reliable, unacted on electric net, pressure and so on. | 
回到页首
